Section 5 – Media Resources
QUESTION 1
When using unicast music on hold, how many streams will be sent to endpoints if a corporate marketing department has a customized message that is played whenever a customer is placed on hold?
A. one
B. one for each message in the music on
C. one for each endpoint placed on hold
D. one per instance of music on hold in the server
Answer: C
QUESTION 2
Which three of these are reasons to deploy media resource access control in a Cisco Unified Communications Manager cluster? (Choose three.)
A. to enable Cisco Unified Communications Manager to share and access the resources that are available across multiple clusters.
B. to enable hardware and software media resources to coexist within Cisco Unified Communications Manager and enable them to be used with different priorities
C. to enable Cisco Unified Communications Manager to perform load distribution within a group of dissimilar media resources
D. to allow media resource access control based on the location of the resource
E. To enable Cisco Unified Communications Manager to perform load distribution within a group of similar media resources
Answer: D
QUESTION 3
If there are media resources that are not assigned to a Media Resource Group, in which situation would a device be allowed to use these devices?
A. if the device were not assigned to a specific media resource group
B. if after looking through the Media Resource Group Lists no media resources were available, then the devices in the NULL media resource group would be used
C. If the device were assigned to the NULL media resource group
D. If after exhausting the search of Media Resource Group Lists in the media resource group, the devices in the NULL media resource group would be used
Answer: B
QUESTION 4
Refer to the exhibit.
Phone A places Phone B on hold. Which two of these identify the audio stream that will be heard and from which server it will be played? (Choose two.)
A. Audio 1
B. Audio 2
C. Audio 3
D. Audio 4
E. Server A
F. Server B
Answer: DF
QUESTION 5
Which three of these are characteristics of multicast music on hold? (Choose three.)
A. It uses one-way RTP point-to-point.
B. There is a single user per audio stream.
C. Networks and devices have to support multicast.
D. It increments by IP address for different audio sources.
E. It uses the multicast group address 239.1.1.1 to 239.255.255.254.
F. It uses enterprise parameters to set the codec type or types used by music on hold services
Answer: CDE
